SHORT ANSWER
USE CONNECTED WEIGHTS AT EVERY REQUIRED LEG.
Concrete prevents normal ground pegging, so use the hard-surface anchoring method and weight specified by the gazebo manufacturer. Keep weights connected to the frame, distribute them around the structure and never rely on weight alone to make an unsuitable weather situation safe.
STEP BY STEP
A SAFER HARD-SURFACE SETUP.
- Read the gazebo instructions.Confirm the required anchoring method and any minimum weight guidance.
- Check the surface and site.Look for slope, traffic, trip hazards, drainage and exposure to gusts.
- Position the gazebo fully.Square the frame, engage its locks and fit it as the manufacturer directs.
- Add connected weights.Place the required weight at each leg and connect it securely rather than leaving it loose nearby.
- Consider walls and exposure.Walls can catch more wind, and exposed sites can experience stronger gusts.
- Monitor and dismantle when needed.Recheck connections during use and take the gazebo down if conditions exceed its safe operating guidance.
USING LUMPET
CLAW ON. STACK IF THE SETUP REQUIRES MORE.
Lumpet wraps around the leg and holds up to 20 kg of sand per bag. Additional bags can be stacked at one leg when the equipment layout and stability allow. Use the wide handle to move each bag, close every buckle correctly and keep the anchor close to the foot.
AVOID THESE MISTAKES
COMMON HARD-SURFACE PROBLEMS.
- Weighting only one side of the gazebo
- Leaving weights loose beside the legs
- Ignoring the effect of fitted walls
- Assuming a calm morning guarantees a calm afternoon
- Using a total weight figure without checking its distribution
- Continuing to use the gazebo outside manufacturer guidance